Download  Print this page

Step 1-Preparing The Workstation - HP Xw4600 - Workstation - 2 GB RAM Installation Manual

Ieee-1394 card
Hide thumbs
   

Advertisement

Step 1—Preparing the workstation
Your workstation documentation includes instructions for disassembling and preparing the workstation
for installation.
To prepare the workstation for component installation:
1.
Power down the workstation.
2.
Disconnect power from the workstation.
3.
Open the access cover.
For product-specific information, see the Service and Technical Reference Guide for your HP
workstation at http://www.hp.com/support/workstation_manuals.
Step 2—Removing the PCI slot cover
Open the PCI retention clamp by pressing down on the clips and moving the clamp toward the rear of
the workstation (1). Choose an open PCI slot. Pull up on the slot cover to remove it from the chassis
(2).
NOTE:
The following illustration is an example only. Your system might look different.
Figure 1
Removing the PCI slot cover
4
IEEE-1394 card installation
ENWW

Advertisement

Table of Contents
loading

  Related Manuals for HP Xw4600 - Workstation - 2 GB RAM

This manual is also suitable for:

Xw seriesXw4000 seriesXw6000 seriesXw4550Xw8000Xw9000