Step 1—Preparing the workstation
Your workstation documentation includes instructions for preparing the workstation for component
installation.
To prepare the workstation for component installation:
1.
Power down the workstation.
2.
Disconnect power from the workstation.
3.
Open the access cover.
For product-specific information, see the Service and Technical Reference Guide for your HP
workstation at http://www.hp.com/support/workstation_manuals.
Step 2—Installing the diskette drive
1.
Remove the front bezel, the necessary bezel blank, and the EMI filler blank (if necessary).
2.
For HP xw8000 and xw9000 Workstation series, insert the diskette drive in the bracket, and secure
the diskette drive by inserting two M3 screws in the rear holes.
3.
Slide the drive into the bay. For an HP xw4000 series workstation, you must add four screws to
secure the diskette drive to the chassis.
4
Diskette drive installation
Figure 1. Installing the drive in the bracket
ENWW