Front I/O Panel Housing Assembly - HP xw3400 - Workstation Technical Reference Manual

Front I/O panel housing assembly

Prepare the workstation for disassembly
1.
Remove the access panel and rotate the workstation so the system board is parallel to the table to
2.
make it easier to work on
Remove the hard drive cables from the plastic shroud at the front of the chassis and from the hard
3.
drives.
Remove the shroud from the chassis
4.
Disconnect the power switch/LED cable, the front USB cable, and the front audio cable from the
5.
system board.
Remove the single screw that secure the housing to the chassis (1), then push the housing to the inside
6.
of the chassis (2).
To install the housing assembly, reverse the removal procedures.
NOTE:
When installing the housing, insert the power-button end into the opening and then rotate the
USB end into position before inserting the retaining screw.
ENWW
(Preparation for disassembly on page
(Access panel on page
(Fan shroud on page
61).
84).
Front I/O panel housing assembly
59).
85