HP xw3400 - Workstation Technical Reference Manual page 20

Table 2-4 Computer Setup—Security (continued)
Network Service
Boot
System IDs
DriveLock Security
OS Security (some
models)
Setup Security Level
10 Chapter 2 Computer Setup (F10) utility
Network controllers (some models)
●
● Embedded security device (some models)
Enables/disables the workstation's ability to boot from an operating system installed on a network
server. (Feature available on NIC models only; the network controller must be either a PCI expansion
card or embedded on the system board.)
Allows you to set:
● Asset tag (18-byte identifier) and ownership tag (80-byte identifier displayed during POST). See
the Desktop Management Guide on the Documentation and Diagnostics CD for more information.
Ownership Tag. This tag is a string that is displayed under the POST splash screen that may be
●
used to identify the owner of the workstation.
Chassis serial number or Universal Unique Identifier (UUID) number. The UUID can only be
●
updated if the current chassis serial number is invalid. (These ID numbers are normally set in the
factory and are used to uniquely identify the system.)
● Keyboard locale setting (for example, U.S. or Deutsch) for System ID entry.
Allows you to assign or modify a master or user password for hard drives. When this feature is
enabled, the user is prompted to provide one of the DriveLock passwords during POST. If neither is
successfully entered, the hard drive will remain inaccessible until one of the passwords is successfully
provided during a subsequent cold-boot sequence.
NOTE: This selection will only appear when at least one drive that supports the DriveLock feature is
attached to the system.
See the Desktop Management Guide on the Documentation and Diagnostics CD for more information.
NOTE:
An OS Security selection is in effect only if the processor and operating system being used
comprehend and utilize the security feature.
Data Execution Prevention (some models) (enable/disable) Helps prevent OS security breaches.
●
Intel Virtualization Technology (some models) (enable/disable) Changing this setting requires
●
turning the workstation off and then back on.
Provides a method to allow end-users limited access to change specified setup options, without having
to know the Setup Password.
This feature allows the administrator the flexibility to protect changes to essential setup options, while
allowing the user to view system settings and configure nonessential options. The administrator
specifies access rights to individual setup options on a case-by-case basis via the Setup Security Level
menu. By default, all setup options are assigned Setup Password, indicating the user must enter the
correct Setup Password during POST to make changes to any of the options. The administrator may
set individual items to None, indicating the user can make changes to the specified options when setup
has been accessed with invalid passwords. The choice, None, is replaced by Power-On Password if
a Power-On Password is enabled.
NOTE:
Setup Browse Mode must be set to Enable in order for the user to enter Setup without knowing
the setup password.
ENWW