Power Supply - HP xw3400 - Workstation Technical Reference Manual
Hp xw3400 workstation - service and technical reference guide
Hide thumbs
Also See for xw3400 - Workstation:
- Installation manual (10 pages) ,
- Quick reference card (2 pages) ,
- Declaration of conformity (1 page)
Table of Contents
Advertisement
Power supply
WARNING!
active AC outlet. To avoid possible personal injury and damage to the equipment the power cord should
be disconnected from the workstation and/or the AC outlet before opening the workstation.
Prepare the workstation for disassembly
1.
Remove the access panel and rotate the workstation so the system board is parallel to the table to
2.
make it easier to work on
Disconnect all power cables from the mass storage devices and from the system board.
3.
Remove the screws that connect the power supply to the chassis (1).
4.
Pull the power supply towards the front of the chassis then, lift the power supply from the chassis (2).
5.
To install the power supply, reverse the removal procedure.
90
Chapter 7 Removal and replacement procedures
Voltage is always present on the system board when the workstation is plugged into an
(Access panel on page
(Preparation for disassembly on page
61).
59).
ENWW
Advertisement
Table of Contents
