HP XM600 - Kayak - 128 MB RAM User Manual page 25

NOTE
Removing the Front Bezel
If required, remove the front bezel. This bezel is divided into two sections:
• The upper bezel (blue) gives access to three 5.25-inch shelves and two
3.5-inch shelves.
• The lower bezel (grey) gives access to the control panel. To access the
lower bezel, you must first remove the upper bezel.
Take care when removing the upper and lower bezels. They are not on a
hinge — do not force them open.
To remove the upper
and lower bezels:
a Unclip the two
clips located on
the left-hand
side of the bezel.
b Open the bezel
slightly, and then
gently push it
outwards.
Replacing the Cover and Front Bezel
1 Ensure that all internal cables are properly connected and safely routed.
2 If necessary, replace the front bezel. To do this, ensure that the bezel is
correctly orientated, align the two plastic tabs with their slots on the
right-hand side of the chassis, and then close the bezel. If you have
removed both sections of the front bezel, first replace the lower bezel.
3 Standing at the back of the PC, lower the cover onto the chassis (aligning
the guide rail on the bottom inside edge of the cover with the bottom
edge of the PC chassis).
4 Shut the cover ensuring that the guides on the top of the cover slide into
the rails at the top of the chassis.
5 Slide the cover forwards, then tighten the two thumbscrews.
6 If required, lock the cover using the key provided. Reconnect all the
power and telecommunications cables.
2 Installing and Replacing Hardware Parts in Your PC Workstation
Removing and Replacing the Cover and Front Bezel
a
a
b
25