Power Connectors - HP XM600 - Kayak - 128 MB RAM User Manual

You should assign an unused SCSI ID to the second SCSI hard disk drive
(for example, SCSI ID 1).
The SCSI ID is usually configured with jumpers on the SCSI hard disk drive.
Refer to the installation guide supplied with the drive for information on
selecting a SCSI ID.
Some internal SCSI disk drives may have termination resistors that must be
removed or disabled before installation in your computer. Refer to the
drive's installation guide for more details and to see if there is a special
installation procedure to follow.

Power Connectors

Power Cable for 3.5-inch Floppy
Disk Drive
Additional Guide Rails
Guide rails are supplied for the installation of additional mass storage
devices. These are inside the PC Workstation, four pairs attached on the
side of the front access bays and one pair on the chassis bar. Depending on
the device to be installed, dedicated guide rails are required and are easily
recognized by their distinct shape, markings and color.
The following table indicates the device, location, and required rails.
Device to be Installed
3½-inch device (2
drive)
3½-inch device (zip drive or
second floppy disk drive)
5¼-inch device (CD-ROM, etc.)
3½-inch device (3
disk drive)
2 Installing and Replacing Hardware Parts in Your PC Workstation
Location
nd
hard disk 3½-inch internal
shelf
3½-inch front
access bay
5¼-inch front
access bay
rd th
or 4 hard 5¼-inch front
access bay
Installing Mass Storage Devices
Power Cables for Hard Disk Drives, Zip
Drives, Tape Drives, CD-RW,
CD-ROM Drives and DVD drives
Required Rails
Blue left and right rails
(L or R indicated on the rail)
Wide green rails (L or R no no no not t t t
indicated on the rail)
Narrow green rails
(L or R indicated on the rail)
Use separate HDD mounting kit.
35