3 Interface Cards
Network Cards
INTEL NIC (Network Interconnect) LAN Card
INTEL NIC LAN Card Features
Feature
IEEE802.3 100 Base-TX,
Interface
IEEE802.3 10 Base-T,
32-bit 10/100 BT full duplex RJ LAN Port.
Two LEDs:
LED
•
•
PCI 2.2 Specification, PC 99.
Labels
Power Management
•
•
•
•
•
•
DMI 2.0 and DMI 2.0 SNMP mapper.
Manageability
Diagnostic
•
•
•
Major OSes, Minor OSes.
Drivers
Onboard flash ROM.
Boot ROM
This feature enables a host computer to remotely (over the network) power
Remote Wake Up
on computers and wake computers up from energy-saving Sleep mode. For
(RWU)
these features to work, use the Setup program to configure the BIOS.
INTEL NIC LAN Card LED Descriptions
LED
On
Adapter and hub are
ACT/LNK
receiving power. Cable
connection is good.
Operating at 100 Mbps
100 TX
84
Description
one for act/lnk (activity and link),
one for 10 MB operation (on = 100 MB, off = 10MB).
Wfm 2.0 compliant,
RPO and RWU for APM Windows 95 and Windows 98,
OnNow 1.0, APM 1.2,
PCI power management 1.1,
VccAux s3.3 V support via PCI bus 2.2,
VccAux 5 V support via 3-pin WOL.
Windows and DOS based,
Mac address DOS report tool,
User Diag for DOS, Windows NT 4, Windows 95 and Windows 98.
Flashing
Receiving or sending
packets
N/A
Off
Adapter and hub are not
receiving power. Cable
connection could be faulty
or there is a driver
configuration problem.
Operating at 10 Mbps