HP XM600 - Kayak - 128 MB RAM Technical Reference Manual page 137

Code #
0522h HDD # 2 not detected (but configured in CMOS)
0523h HDD # 3 not detected (but configured in CMOS)
0530h Found a drive on slave connector only (primary)
0531h Found a drive on slave connector only (secondary)
0600h Found less video memory than configured in CMOS
0700h Found less DRAM memory than at previous boot
0711h Defective SIMM (module 1, bank 1)
0800h Found lower cache size than configured
0801h Cache self-test failure
0A00h Plug and Play video auto-setting failure (DDC hang)
The following table summarizes the most significant of the problems that
can be reported.
Message
Operating system not found
Missing operating system
Resource Allocation Conflict -PCI device
0079 on system board
Video Plug and Play interrupted or
failed. Re-enable in Setup and try again
System CMOS checksum bad - run
Setup
No message, system "hangs"
Cause / Symptom
Explanation or Suggestions for Corrective Action
Check whether the disk, HDD, FDD or CD-ROM disk drive is
connected.
If it is connected, check that it is detected by POST.
Check that your boot device is enabled on the Setup Security
menu.
If the problem persists, check that the boot device contains the
operating system.
If you have configured HDD user parameters, check that they are
correct. Otherwise, use HDD type "Auto" parameters.
Clear CMOS.
You may have powered your computer Off/On too quickly and the
computer turned off Video plug and play as a protection.
CMOS contents have changed between 2 power-on sessions. Run
Setup for configuration.
Check that the main memory modules are correctly set in their
sockets.
6 Tests and Error Messages
Error Message Summary
Short message (US)
IDE Device # 2 Error
IDE Device # 3 Error
IDE Device Error
IDE Device Error
Video Memory Error
System Memory Error
System Memory Error
System Cache Error
System Cache Error
DDC Video Error
137