Configure Default Control-Panel Settings - HP Color LaserJet 9500 Administrator's Manual

Multifunction finisher
Hide thumbs Also See for Color LaserJet 9500:
Table of Contents

Advertisement

Configure default control-panel settings

Change the default job offset, default stapler actions, and default fold line adjustments through the
control panel.
Configure control-panel settings on the HP LaserJet 9050, HP LaserJet 9040mfp, HP LaserJet 9050mfp,
HP Color LaserJet 9500, and HP Color LaserJet 9500mfp Series
1.
Press
2.
Use
3.
Use
Configure control-panel settings on the HP LaserJet M9040 MFP and HP LaserJet M9050 MFP
1.
Scroll to and touch Administration.
2.
Scroll to and touch
3.
Scroll to and touch
The following tables describe the control-panel settings for the HP Multifunction Finisher.
NOTE:
The system administrator can limit access to the job offset and default stapler actions.
Table 2-1
OFFSET
No
Yes
NOTE:
The offset function is available only in the stacker bin (bin 1) and only for jobs that are not
stapled. You can select the available stapler action through the printer driver (for example, use of one
staple or two staples).
Table 2-2
STAPLES
NONE
ONE
TWO
8
Chapter 2 Finisher tasks
to enter the menus.
and
to scroll to
CONFIGURE
and
to scroll to
MULTIFUNC.
Device
Behavior.
Multifunct.
Finisher.
DEVICE, and press
FINISHER, and press
When the
OFFSET
mode is off, all of the jobs are stacked with
no separation.
When the
OFFSET
mode is on, the device automatically
separates complete jobs or mopies (multiple original prints of
a single job). Each job or mopy is separated by setting the jobs
apart from each other (for unstapled jobs).
If the default action is set to NONE, the job is not stapled.
If the default action is set to ONE, the staple is placed in the
top left corner of the document. If you are printing in landscape
format, the staple location is automatically adjusted for
placement in the top left corner of the landscape layout.
If the default action is set to TWO, two staples are used with
one job or with mopies. Both staples are placed parallel to the
edge closest to the printer (the trailing edge).
.
.
ENWW

Advertisement

Table of Contents
loading

Table of Contents