HP Workstation xw4100 Hardware Installation Manual page 4

The attachment point for the Solenoid Lock may be located on the back panel or the top panel of the
computer chassis.
1. Ensure that the security pin in the Solenoid Lock assembly is in the OFF position, as illustrated.
If the pin is up, push it down to the OFF position.
Figure 2
2. Install the new lock assembly (1) on the inside of the rear panel or top panel of the computer
using the two tamper-resistant screws (2) and the FailSafe Key included in this kit.
NOTE:
or may be installed on the other side of the system fan grill or on the top panel of the computer.
3. Plug the loose end of the Solenoid Lock cable into the appropriate connector on the system
board (3). Be sure to route the cable so it is not interfering with other system board connectors
or computer components.
NOTE:
access panel. On some HP Workstations, such as the HP Z600 Workstation series, the Solenoid
Lock cable does not connect to the system board.
Figure 3
4 Installing an HP Solenoid Lock and Hood Sensor
Security pin in the OFF position
On some computer models, the Solenoid Lock may look different than the one pictured,
To locate system components on HP Workstations, see the service label on the side
Installing the Solenoid Lock assembly
ENWW