HP Workstation xw4100 Hardware Installation Manual page 3

Hp solenoid lock and hood sensor installation guide

Hide thumbs Also See for Workstation xw4100:

Installing the Hood Sensor

NOTE:

Computer models vary, and all illustrations are examples only. For product-specific

information, see the service guide for your HP computer at

before beginning installation.

The attachment point for the Hood Sensor may be located on the front panel, back panel, or sheet

metal of the computer chassis, the plastic fan-duct housing, or the expansion card guide.

If necessary, install the Hood Sensor bracket, using the screws provided in the kit.

NOTE:

provided in the kit. If the computer has only one hole, only one screw is needed.

Push the Hood Sensor up through the rectangular hole in the bracket, chassis, card guide or fan

duct housing, and then slide it forward or backwards (1) in the rectangular hole until it locks into

place.

Plug the loose end of the Hood Sensor cable into the appropriate connector on the system board

(2). Be sure to route the cable so it does not interfere with other system board connectors or

computer components.

NOTE:

access panel.

Figure 1

Installing the Solenoid Lock

NOTE:

Computer models vary, and all illustrations are examples only. For product-specific

information, see the service guide for your HP computer at

before beginning installation.

ENWW

If the computer has two holes for mounting the bracket, use both of the screws

To locate system components on HP Workstations, see the service label on the side

Installing the Hood Sensor

http://www.hp.com/support/manuals

Installing the Hood Sensor

Table of Contents