Epson SureLab D3000 - Double Roll Administrator's Manual page 44

Create Calibration
Click Create Calibration (0343) from Color
Calibration (034) to display the screen.
Create the calibration file to be used in Calibration
(0341).
Tip:
O You can create a standard value for each paper
surface type.
O The initial calibration file provided contains
standard values for a standard printer. When
reducing the color differences between multiple
printers, select the calibration file created by the
main printer.
Note:
O You need a color measurement device to perform
calibration. The following models are supported.
The "i1Pro" from X-Rite (with or without a UV
O
filter)
The "i1iSis" from X-Rite
O
O When using a color measurement device, install
the software for the measurement device in
advance on the Client PC (the PC that will perform
the calibration).
O Consult service personnel for more information on
preparing and setting up the color measurement
device.
Settings/Maintenance
A
Select the roll paper feeder used for printing in
Paper.
Tip:
Only the Dual Roll Model supports front roll
paper. For the Single Roll Model, see the
information for rear roll paper.
B
Select the color measurement device.
C
Enter the Calibration File Name.
Enter the file name of the calibration.
You can enter a file name that complies with
Windows operating system restrictions.
If the file name already exists, a screen is
displayed asking if you want to overwrite the
file.
D
Click Print from Calibration Creation Phase.
A confirmation screen is displayed.
E
Click Yes.
Click No to cancel printing.
For a Glossy or Luster surface type, two charts
are printed. These are standard and high image
quality charts.
For a Matte surface type, one standard chart is
printed.
45