Epson SureLab D3000 - Double Roll Administrator's Manual page 42

Create, verify, and write the correction value
A
Click Create Correction Value from
Correction Value Creation Phase.
The correction value is created.
B
Click Print from Correction Value Verification
Phase.
For Use Standard Value for Collective Creation,
a total of three charts are printed. These include
standard and high image quality for
Glossy/Luster, and standard for Matte.
For Specify Standard Value using Glossy/Luster
surface type, a total of two charts are printed.
These include standard and high image quality.
For Specify Standard Value using Matte surface
type, one standard chart is printed.
Tip:
O Nozzle Check is performed automatically
before printing. If clogging is detected in the
head, print again after cleaning the head
and clearing the clogged nozzles.
U "Head Cleaning" on page 27
O The number of charts printed varies
depending on the settings and the paper.
Settings/Maintenance
C
The following screen is displayed after printing
the first sheet. Follow the on-screen
instructions, and then click OK.
The charts the second sheet and after are
printed.
D
Wait for 30 minutes until drying is complete.
Check the drying time displayed on Status.
When the drying time reaches 0, Drying
complete. is displayed, and the Measure Color
button becomes available.
E
Click Measure Color from Correction Value
Verification Phase.
F
Perform color measurement in the color
measurement device in the same way as color
measurement for the correction chart.
U "Correction chart color measurement (for
the "i1Pro")" on page 40
U "Correction chart color measurement (for
the "i1iSis")" on page 42
43