Epson SureLab D3000 - Double Roll Administrator's Manual page 39

Correction chart color measurement (for the
"i1Pro")
A
Check that the color measurement device you
want to use is connected.
Tip:
For more information on color measurement
device, see the document supplied with the
device.
B
Click Measure Color from Correction Value
Creation Phase.
C
Place the color measurement device on the
calibration base plate, and then click OK.
Performs color measurement for the white
calibration tile.
Settings/Maintenance
D
Place the correction chart that matches the color
chart ID and preset ID displayed on the screen
on the measurement backup board supplied
with the color measurement device.
Place the chart on white paper if there is no
backup board available for measurement.
Tip:
O The color chart ID and preset ID are printed
O If a correction chart sticks out beyond the
E
Click OK.
Color measurement starts.
F
Select Color Measurement Method.
Select a Line Scan to perform color
measurement for each line, or select Spot Scan
to perform color measurement for each patch.
40
at the bottom of the correction chart.
edge of the measurement backup board, cut
off the margin along the cutoff line on the
chart.