Epson SureLab D3000 - Double Roll Administrator's Manual page 40

Tip:
O Select Line Scan to perform color
measurement quickly. If the results of color
measurement using Line Scan are not what
you expected, try Spot Scan.
O When performing color measurement with
Line Scan, use the chart measurement ruler
supplied with the color measurement device.
O When performing color measurement with
Spot Scan, use the spot measurement guide
supplied with the color measurement device.
G
Perform color measurement in the order of the
range displayed on the screen.
To change the scanning range, move by clicking
the arrow buttons on the screen.
When performing color measurement in Line
Scan, match the color measurement device to
the measurement ruler being used, hold down
the button on the side, and slowly move over the
patch to scan.
When performing color measurement with Spot
Scan, adjust the measurement guide so that it is
over the target patch, place the color
measurement device, and then press the button
on the side.
When reading is successful, the data is displayed
on the screen where the correction chart is read.
When reading fails, an "X" is displayed on the
screen where the correction chart is read. In this
case, try reading again.
Settings/Maintenance
Tip:
O The color measurement range differs
O For more information on color
H
When color measurement is complete, click
OK.
Continue to create the correction value.
U "Create, verify, and write the correction value" on
page 43
41
depending on the Color Measurement
Method selected.
measurement device, see the document
supplied with the device.