HP Rp3000 - Point of Sale System Hardware Reference Manual page 43

Hardware reference guide - hp rp3000

Hide thumbs Also See for Rp3000 - Point of Sale System:

Table of Contents

Place jumpers and jumper wires on the appropriate pins for COM 3 (1) and COM 4 (2). (See

Table C-1 Configuring Serial Port Power on page 39

Figure C-9

To install the Powered Serial Port Expansion Card, align the bracket on the card with the open

slot on the rear of the chassis and press the card straight into the expansion socket (1).

Replace the screw that secures the card to the chassis (2).

NOTE:

connector seats properly in the expansion card slot.

Figure C-10

ENWW

COM 3 and COM 4 Jumpers

When installing an expansion card, press firmly on the card so that the whole

Installing the Powered Serial Port Expansion Card

to determine the appropriate pins.)

Configuring Power to a Serial Port

Table of Contents