HP Rp3000 - Point of Sale System Hardware Reference Manual page 35

Hardware reference guide - hp rp3000

Hide thumbs Also See for Rp3000 - Point of Sale System:

Table of Contents

To install the new PoweredUSB expansion card, lower the card into the chassis (1), install the

screws that fasten the card to the chassis (2), and connect the cables to the card (3).

NOTE:

remove the panel.

You may need to remove the power cable from the clamp on the chassis so that it will reach the

power connector on the card.

If a ReadyBoost module is installed, you must remove it in order to plug in the Powered USB

expansion card.

Figure B-5

Return the drive cage to the down position.

Figure B-6

10.

Replace the computer cover.

ENWW

If there is a panel covering the opening for the ports on the rear of the chassis, you must

Installing the PoweredUSB Expansion Card

Lowering the Drive Cage

Table of Contents