IBM NetVista Type 6049 and 2259 Refresh 1.1
Version: HMM02
7
.Close the door panel. This completes
the setup for the CD-ROM drive.
8
.Next, you should get familiar with the
cables that are used with the various
drives. The first cable is use for the
floppy drives, the second cable is for the
hard disk drive and the third long cable is
use for the CD-ROM drive.
For the power cables, the cable has
peripheral and floppy drive power
connector and is designed to connect
from the power supply to the drives.
9
.Plug the CD-ROM cable into the
Primary IDE channel on the mainboard.
The edge of the cable that is red
determines its orientation. Push the
CD-ROM cable squarely onto the
Primary pins.
19 of 35