Serverlayout" Section - HP c3700 - Workstation Administration Manual

NOTE
Chapter 3
• String - a sequence of characters
• Boolean - a boolean value (see below)
• Frequency - a frequency value (see below)
All Option values, not just strings, must be enclosed in quotes.
Boolean options may optionally have a value specified. When no value is
specified, the option's value is TRUE. The following boolean option
values are recognized as TRUE:
1, on, true, yes
and the following boolean option values are recognized as FALSE:
0, off, false, no
If an option name is prefixed with "No", then the option value is negated.
Frequency option values consist of a real number that is optionally
followed by one of the following frequency units:
Hz, k, kHz, M, MHz
When the unit name is omitted, the correct units will be determined from
the value and the expectations of the appropriate range of the value. It is
recommended that the units always be specified when using frequency
option values to avoid any errors in determining the value.

"ServerLayout" section

The ServerLayout section is used to identify which Screen sections are
to be used in a multi-headed configuration, the relative layout of those
screens, and which InputDevice sections are to be used. Each
ServerLayout section has an Identifier, a list of Screen section
identifiers, and a list of InputDevice section identifiers. Options may
also be included in the ServerLayout section. A ServerLayout section
may be made active by referencing (via its Identifier) on the command
line that starts X. In the absence of this, the first one found in the file
will be chosen by default, as there may be multiple ServerLayout
sections in the config file. The format of the ServerLayout section is as
follows:
configuring X Windows on HP-UX (other graphics cards)
the XF86Config file
37