Monitor" Section - HP c3700 - Workstation Administration Manual

Chapter 3
Option flags may be specified in the Display subsections. These may
include driver-specific options or driver-independent options. The former
are described in the driver-specific documentation. Some of the latter are
described above in the section about the Screen section, and they may
also be included here. However, options set in the Display subsection
may be "overridden" in the Screen section.

"Monitor" section

The configuration file may have multiple Monitor sections. The
Monitor section provides information about the specifications of the
monitor, monitor-specific Options, and information about the video
modes to use with the monitor. There must be at least one Monitor
section, for the monitor being used. A Monitor section is considered
"active" if it is referenced by an active Screen section. Monitor sections
have the following format:
Section ìMonitorî
Identifier
VendorName ìVnameî
ModelName
HorizSync
VertRefresh
DisplaySize
Gamma [gamma-value|{red-gamma green-gamma blue-gamma}]
GammaAllLayers [on | true | 1]
EndSection
The Identifier entry specifies the unique name for this monitor.
The VendorName is an optional entry and is used to specify the
monitor's manufacturer.
This ModelName is an optional entry that is used to specify the monitor
model.
HorizSync gives the range(s) of horizontal sync frequencies supported
by the monitor. horizsync-range may be a comma separated list of either
discrete values or ranges of values. A range of values is two values
separated by a dash. By default the values are in units of kHz. They may
be specified in MHz or Hz if MHz or Hz is added to the end of the line.
configuring X Windows on HP-UX (other graphics cards)
ìMonitorIDî
ìMnameî
horizsync-range
vertrefresh-range
width height
the XF86Config file
49