Defining General Qos Settings; Configuring Qos General Settings - HP BladeSystem bc2000 - Blade PC User Manual

Configuring Quality of Service

Defining General QoS Settings

This section contains information for defining general QoS settings and includes the following
topics:
■

Configuring QoS General Settings

■
Restoring Factory Default QoS Interface Settings
■
Defining Queues
■
Defining Rate Limiting
■
Mapping CoS Values to Queues
■
Mapping DSCP Values to Queues
Configuring QoS General Settings
The CoS page contains information for enabling QoS globally and on specific interfaces. After
QoS has been configured, the original device QoS default settings can be reassigned to the
interface in the CoS page.
To enable QoS:
1. Click QoS > General > CoS. The CoS page opens:
CoS
The CoS page contains the following fields:
❏
QoS Mode — Determines whether QoS mode is enabled on the interface. The possible
values are:
◆
Disable — Disables QoS on the interface.
◆
Basic — Enables QoS Basic mode on the interface.
◆
Advanced — Enables QoS Advanced mode on the interface.
13-2 www.hp.com Embedded Web System User Guide