Advertisement
CR
Module
Level
CR00012786
IP Gateway
CR00012895
IP Gateway
CR00012947
Log
CR00013007
IPsec
CR00013048
Firewall
Version 281-01
C613-10482-00 REV A
3
When a link that had RIP configured on it went down, so that the router or switch
used an alternative route, output from the command show ip route sometimes
displayed incorrect information when the link came back up. When the link first
comes back up, the route's RIP metric is still 16, so the alternative route is still the
"best" route to the target. However, show ip route sometimes displayed a
disabled route over the original link, with a RIP metric of 16, as the best route,
even though the router or switch correctly used the alternative route.
This issue has been resolved.
3
Previously, the router accepted ARP entries with multicast IP and MAC addresses
when the MAC disparity feature was disabled. The MAC disparity feature is
disabled by default.
The issue has been resolved. The router now discards such ARP entries unless the
MAC disparity feature has been enabled by using the command enable ip
macdisparity.
3
When a user entered the command show log receive=ipadd mask=mask, the
router or switch displayed an error message that said mask was not a valid
parameter.
This issue has been resolved. The mask parameter is now valid for this command.
3
With tunnel-mode IPsec, the router or switch decremented the time to live (TTL)
of IP packets twice when it forwarded the packets through the tunnel.
This issue has been resolved.
3
When IP NAT or firewall NAT was used, the router or switch sometimes generated
ICMP messages that specified the wrong source IP address. This meant that the
response to traceroute could be incorrect.
This issue has been resolved.
Description
Features in 281-01
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
-
-
-
-
-
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
-
-
-
Y
Y
Y
Y
Y
-
-
-
15
Y
Y
-
-
Y
Y
-
-
-
-
Advertisement
