System Memory (Dimm) - Asus P2B-D User Manual

III. INSTALLATION

2. System Memory (DIMM)

This motherboard uses only Dual Inline Memory Modules (DIMMs). Sockets are
available for 3.3Volt (power level) unbuffered Synchronous Dynamic Random Ac-
cess Memory (SDRAM). One side (with memory chips) of the DIMM takes up one
row on the motherboard.
To utilize the chipset's Error Checking and Correction (ECC) feature, you must use a
DIMM module with 9 chips per side (standard 8 chips/side + 1 ECC chip) and make
the proper settings through "Chipset Features Setup" in IV. BIOS SOFTWARE.
Memory speed setup is recommended through SDRAM Configuration under "Chipset
Features Setup".
Install memory in any combination as follows:
DIMM Location
Socket 1 (Rows 0&1)
Socket 2 (Rows 2&3)
Socket 3 (Rows 4&5)
Socket 4 (Rows 6&7)
NOTE: At the time this User's Manual was written, 256MB DIMMs are only avail-
able as registered memory.
General DIMM Notes
• Use only PC100-compliant DIMMs. This motherboard operates at 100MHz, thus most
systems will not even boot if non-compliant modules are used because of the strict tim-
ing issues involved under this speed.
•
Two possible memory chips are supported: SDRAM with and without ECC.
• SDRAM chips are generally thinner with higher pin density than EDO (Extended Data
Output) chips.
• BIOS shows SDRAM memory on bootup screen.
• 8 chips/side modules do not support ECC, only 9 chips/side modules support ECC.
• Single-sided DIMMs come in 16, 32, 64, 128MB; double-sided come in 32, 64, 128, 256MB.
ASUS P2B-D/P2B-DS User's Manual
168-pin DIMM Memory Modules
SDRAM 8, 16, 32, 64, 128, 256MB
SDRAM 8, 16, 32, 64, 128, 256MB
SDRAM 8, 16, 32, 64, 128, 256MB
SDRAM 8, 16, 32, 64, 128, 256MB
Total System Memory (Max 1GB)
Total Memory
x1
x1
x1
x1
=
17