Asus P2B-D User Manual page 32

14. LED Lead (MSG.LED)
This indicates whether a message has been received from a fax/modem. The
LED will remain lit when there is no signal and blink when there is data transfer
or waiting in the inbox. This function requires ACPI OS and driver support.
15. System Management Interrupt Switch Lead (SMI)
This allows the user to manually place the system into a suspend mode or "Green"
mode where system activity is decreased to save electricity and expand the life
of certain components when the system is not in use. This 2-pin connector con-
nects to the case-mounted suspend switch. If you do not have a switch for the
connector, you may use the "Turbo Switch". SMI is activated when it detects a
short to open moment and therefore leaving it shorted will not cause any prob-
lems. This may require one or two presses depending on the position of the
switch. Wake-up can be controlled by settings in the BIOS but the keyboard will
always allow wake-up (the SMI lead cannot wake up the system). If you want to
use this connector, set "Suspend Mode" under the Power Management Setup
of the BIOS SOFTWARE section to the preferred time after which the system
must go into suspend mode when you press the switch.
16. ATX Power Switch / Soft Power Switch (PWR.SW)
The system power is controlled by a momentary switch connected to this lead.
Pushing the button once will switch the system between ON and SLEEP or ON
and SOFT OFF, depending on your BIOS or OS setting. Pushing the switch
while in the ON mode for more than 4 seconds will turn the system off. The
system power LED shows the status of the system's power.
17. Reset Switch Lead (RESET)
This 2-pin connector connects to the case-mounted reset switch for rebooting
your computer without having to turn off your power switch. This is a preferred
method of rebooting to prolong the life of the system's power supply.
18. System Power LED (PWR.LED)
This 3-pin connector connects the system power LED, which lights when the
system is powered on and blinks when it is in sleep mode.
19. Keyboard Lock Switch Lead (KEYLOCK)
This 2-pin connector connects to the case-mounted key switch to allow key-
board locking.
20. Speaker Connector (SPEAKER)
This 4-pin connector connects to the case-mounted speaker.
P2B-D/DS System Panel Connections
32
III. INSTALLATION
Power LED
ASUS P2B-D/P2B-DS User's Manual
Keyboard Lock
Speaker
Connector
Reset SW
MSG LED
ATX Power Switch*
SMI Lead
* Requires an ATX power supply.