System Memory (Dimm) - Asus P2B-F User Manual

III. INSTALLATION

2. System Memory (DIMM)

This motherboard uses only Dual Inline Memory Modules (DIMMs). Four sockets
are available for 3.3Volt (power level) unbuffered Synchronous Dynamic Random
Access Memory (SDRAM). One side (with memory chips) of the DIMM takes up one
row on the motherboard.
To utilize the chipset's Error Checking and Correction (ECC) feature, you must use a
DIMM module with 9 chips per side (standard 8 chips/side + 1 ECC chip) and make
the proper settings through "Chipset Features Setup" in BIOS setup.
Memory speed setup is recommended through SDRAM Configuration under "Chipset
Features Setup" in BIOS setup.
Install memory in any combination as follows:
DIMM Location
Socket 1 (Rows 0&1)
Socket 2 (Rows 2&3)
Socket 3 (Rows 4&5)
Socket 4 (Rows 6&7)
General DIMM Notes
• For the system CPU bus to operate above 100MHz, use only PC100-compliant
DIMMs . This motherboard operates at 100MHz, thus most systems will not even boot if
non-compliant modules are used because of the strict timing issues involved under this
speed. If your DIMMs are not PC100-compliant, set the CPU bus frequency to 66MHz
for system stability.
•
Two possible memory chips are supported: SDRAM with and without ECC.
• SDRAM chips are generally thinner with higher pin density than EDO (Extended Data
Output) chips.
• BIOS shows SDRAM memory on bootup screen.
• 8 chips/side modules do not support ECC, only 9 chips/side modules support ECC.
• Single-sided DIMMs come in 16, 32, 64,128MB; double-sided come in 32, 64, 128, 256MB.
168-pin DIMM
SDRAM 8, 16, 32, 64, 128, 256MB
SDRAM 8, 16, 32, 64, 128, 256MB
SDRAM 8, 16, 32, 64, 128, 256MB
SDRAM 8, 16, 32, 64, 128, 256MB
Total System Memory (Max 1024MB) =
ASUS P2B-F User's Manual
Total Memory
x1
x1
x1
x1
17