Asus P2B-D User Manual page 53

IV. BIOS SOFTWARE
DMA x Used By ISA (No/ICU)
These fields indicate whether or not the displayed DMA channel for each field is
being used by a legacy (non-PnP) ISA card. Available options include: No/ICU and
Yes. The first option, the default setting, indicates either that the displayed DMA
channel is not used or an ICU is being used to determine if an ISA card is using that
channel. If you install a legacy ISA card that requires a unique DMA channel, and
you are not using an ICU, you must set the field for that channel to Yes.
ISA MEM Block BASE (No/ICU)
This field allows you to set the base address and block size of a legacy ISA card that
uses any memory segment within the C800H and DFFFH address range. If you
have such a card, and you are not using an ICU to specify its address range, select a
base address from the six available options; the ISA MEM Block SIZE field will
then appear for selecting the block size. If you have more than one legacy ISA card
in your system that requires to use this address range, you can increase the block
size to either 8K, 16K, 32K, or 64K. If you are using an ICU to accomplish this task,
leave ISA MEM Block BASE to its default setting of No/ICU.
Onboard AHA BIOS (Auto)
The default uses Auto settings for the onboard Adaptec 7890 SCSI BIOS. If you do
not want to use the onboard Adaptec 7890 SCSI BIOS, choose Disabled.
ONB AHA BIOS First (No)
This field allows giving priority to the onboard SCSI BIOS for SCSI functions over
other SCSI controllers. The default is No.
ONB SCSI SE Term. (Enabled)
This allows you to enable or disable the onboard termination for single-ended (SE)
devices, such as scanners, CD-ROMs, or tape drives. The default is Enabled.
ONB SCSI LVD Term. (Enabled)
This allows you to enable or disable the onboard termination for Ultra2 devices,
such as disk drives, using low voltage differential (LVD) technology. LVD allows
the onboard SCSI chipset to support a maximum of 15 devices on a 12m cable, a
fourfold increase over UltraSCSI cable length. In a point-to-point configuration, the
cabling can be extended up to 25m. This increased length allows greater flexibility
in your system configuration, especially in RAID and clustering applications. The
default for this field is Enabled.
USB IRQ (Enabled)
Enabled reserves an IRQ# for the USB to work, Disabled does not allow the USB to
have an IRQ# and therefore prevents the USB from functioning. If you are not using
any USB devices, you may set this feature to Disabled to save an extra IRQ# for
expansion cards.
VGA BIOS Sequence (PCI/AGP)
You can select the search order for your VGA card(s). PCI/AGP will detect PCI
VGA cards before AGP, and AGP/PCI will detect AGP cards before PCI VGA.
ASUS P2B-D/P2B-DS User's Manual 53