Wep Security Options - NETGEAR WGX102 - 54 Mbps Wall-Plugged Wireless Range Extender Reference Manual

Reference Manual for the 54 Mbps Wall-Plugged Wireless Range Extender WGX102
Note: If you use a wireless computer to configure wireless settings, you will be
disconnected when you click Apply. Reconfigure your wireless adapter to match the
new settings or access the wireless range extender from a wired computer to make any
further changes.
9. Click Apply to save your changes.
10. Configure and test your computers for wireless connectivity.
Verify that the wireless adapters of your computers have the same SSID and security options
that you configured in the WGX102. Check that they have a wireless link and are able to
obtain an IP address by DHCP from the wireless range extender.
Once your computers have basic wireless connectivity to the WGX102, you can configure the
advanced wireless security functions of the wireless range extender.

WEP Security Options

To configure WEP data encryption, follow these steps:
Note: If you use a wireless computer to configure WEP settings, you will be
disconnected when you click Apply. You must then either configure your wireless
adapter to match the wireless range extender WEP settings or access the wireless range
extender from a wired computer to make any further changes.
1. Click Wireless Settings in the main menu of the WGX102.
2. From the Security Options menu, select WEP. The WEP options display.
Wireless Configuration and Security
202-10042-02 v1.1
5-9