The Label On The Rear Panel Of The Wgx102; The Wgx102 Bottom Panel - NETGEAR WGX102 - 54 Mbps Wall-Plugged Wireless Range Extender Reference Manual

Reference Manual for the 54 Mbps Wall-Plugged Wireless Range Extender WGX102

The Label on the Rear Panel of the WGX102

The label on the rear panel of the WGX102 contains the items listed below.
• MAC address
• Model number
• Serial number
• Unique device Passcode (PWD)

The WGX102 Bottom Panel

The factory default reset push button is located on the bottom panel of the WGX102, as shown
below.
Figure 2-2: WGX102 Underside
Use a fine pen point or an unfolded paper clip to push in the reset button. If you press the reset
button for less than 15 seconds, the WGX102 does a soft reset, similar to unplugging and then
plugging the device in again.
When you press the reset button for 15 seconds or more, the WGX102 resets to the factory
defaults, as described in
page 8-7.
Introduction
"Restoring the Default WGX102 Configuration and Password" on
202-10042-02 v1.1
2-5