Configure Wep - NETGEAR EX6200 User Manual

4. Select Settings > Wireless.
5. Scroll down to either the Security Options (2.4GHz) section (shown in the previous figure) or
the Security Options (5GHz) section, and select the WPA-PSK [TKIP], WPA2-PSK [AES],
or WPA-PSK [TKIP] + WPA2-PSK [AES] radio button.
6. In the PassPhrase field, enter the passphrase.
7. Click the Apply button.
Your settings are saved.
8. If you are disconnected, reconnect your WiFi device to the extender's network with its new
settings.
Smart Setup can guide you through this process. For more information, see
Setup Again After Initial Setup

Configure WEP

WEP is legacy WiFi security that limits the wireless mode to the Up to 54 Mbps selection,
irrespective of whether you use the 2.4 GHz band or the 5 GHz band. Unless your WiFi
network includes devices that do not support WPA2 or WPA security, NETGEAR
recommends that you use WPA2, WPA, or WPA + WPA2 security.
Note: 802.11ac and 802.11n devices do not support WEP security. If you
change the security to WEP, 802.11ac devices and 802.11n devices in
either the 2.4 GHz or 5 GHz band cannot join the network.
Note: WPS does not support WEP security. If you change the security to
WEP, you can no longer let WiFi devices join the extender's WiFi
network by using WPS.
Manage the Extender Network and Security Settings
AC1200 WiFi Range Extender
on page 69.
55
Run Smart