Now, Add The Wgx102 To Your Wireless Network - NETGEAR WGX102 - 54 Mbps Wall-Plugged Wireless Range Extender Reference Manual

Reference Manual for the 54 Mbps Wall-Plugged Wireless Range Extender WGX102
Plug the WGX102 into an electrical outlet near the wireless computer that you want to connect,
and wait one minute. All three LEDs on the WGX102 light up.
• Power: The power light should turn solid green. If it does not, see
Troubleshooting Tips" on page
• HomePlug/Internet: The Internet port light should be lit. If not, make sure the Ethernet cable
on the XE102 you connected in the previous step is securely attached to the XE102 and the
router, that the router is connected to the modem, and the modem is powered on.
• Wireless: The Wireless light should be lit. If the Wireless light is not lit, see
Troubleshooting Tips" on page
This completes the powerline installation. You may connect additional XE102 bridges to your
network.

Now, Add the WGX102 to Your Wireless Network

Note: The WGX102 must be configured with the same
wireless and IP address settings as your existing network.
Figure 3-6: Powerline and wireless network interconnections
There are two scenarios for adding the WGX102 to your wireless network:
Installing the Wireless Range Extender
3-9.
3-9.
Wireless Network
XE102
Wireless Network
WGX102
202-10042-02 v1.1
"Basic Installation
Internet
Access
Wireless
Router
Wireless
Computer
"Basic Installation
3-5