Configuring The Lan Ip Setup Options In Access Point Mode - NETGEAR WGX102 - 54 Mbps Wall-Plugged Wireless Range Extender Reference Manual

Reference Manual for the 54 Mbps Wall-Plugged Wireless Range Extender WGX102
Use the Wireless Settings link in the Setup section of this page to update the WGX102
wireless settings so that they match your wireless network. For assistance with this task, refer
to "Setting Up and Testing Basic Wireless Connectivity" on page
Logout, the wireless range extender will wait five minutes after there is no activity before it
automatically logs you out.

Configuring the LAN IP Setup Options in Access Point Mode

LAN IP Setup is under the Advanced heading on both the Access Point Mode and Router Mode
menus. If you are using the WGX102 in Router Mode, see
on page 7-24 for configuration information.
From the main menu of the browser interface, under Advanced, click LAN IP Setup to view the
LAN IP Setup menu, shown below.
Figure 3-17: LAN IP Setup menu
DHCP
If selected, the WGX102 will obtain its IP address automatically from a DHCP (Dynamic Host
Configuration Protocol) server. Select this option only if your LAN has a DHCP server.
Fixed IP
Select this option if your LAN does not have a DHCP server or if you want the Access Point to use
a fixed IP address. The WGX102 default LAN IP configuration is:
3-16
"Router Mode LAN IP Setup Options"
Installing the Wireless Range Extender
202-10042-02 v1.1
5-7. If you do not click