Gutter; Creating A Gutter; Staple - Kyocera FS-C8650DN Driver Manual

Finishing

Gutter

Creating a Gutter

1
2
3
4
5

Staple

6-5
To select Custom for Position, click Settings. In the Custom Finishing Edge
Settings dialog box, select one of the settings. The illustrations in the dialog
box help you visualize the page alignments.
In the Custom Finishing Edge Settings dialog box:
The top two settings (A4/Letter) are for the smaller size paper in the mixed
page document.
The second row of settings (A3/Legal/Ledger) is for the larger size paper in
the mixed page document.
Note that a change to one custom Finishing edge setting adjusts other
selections to make them compatible with the change.
Gutter increases the margins around your text and graphics on the left side and
at the top of the printed sheet. Gutter is often used for binding, hole punch, or
stapling to make a print job easier to read. This creates a larger margin space
by shifting the printable area to the right, or down, as much as one inch (25.4
mm).
You can increase the margins on the left side and at the top of the printed sheet.
In the Finishing tab, click Gutter.
In the Gutter width options, type or select a value between 0.20 to 1.00 inches
(5.0 to 25.4 mm).
Short edge (top)
This selection modifies the outside margin on the top-edge of the page.
Long edge (left)
This selection modifies the outside margin on the left-side of the page.
Note: Availability of Gutter settings vary depending on Finishing edge
settings, and Orientation and Duplex settings in the Basic tab.
If text extends too close to the edge of the page, select Reduce image to fit.
The text appears slightly reduced and away from the edge of the page. If text
does not extend beyond the page when the gutter increases, clear Reduce
image to fit.
Click OK to return to the Print dialog box.
Click OK to start printing.
The Staple feature lets you create stapled document sets. You must first select
a finisher under Device Settings > Device options. Selecting the Staple
feature makes Separation and Transparency interleaving unavailable. The
maximum number of sheets depends upon the finisher model and the selected
Page size or Media type. The Gutter feature lets you increase the top and left
margins to accommodate the location of the staples.
User Guide