Scaling; Setting Scaling On The Page; Gutter; Creating A Gutter - Kyocera ECOSYS FS-1035MFP/DP Printer Driver User Manual

5
6

Scaling

Setting Scaling on the Page

1
2
3

Gutter

Creating a Gutter

1
2
3
Printer Driver
Click OK to return to the Print dialog box.
Click OK to start printing.
Scaling increases or decreases text and graphics on a page. You can also
select a gutter setting that enlarges the margins to accommodate manual
stapling or manual hole punch.
Scaling is unavailable when other Layout tab options are selected.
You can increase or decrease text and graphics on a page.
In the Layout tab, type or select a scaling percentage between 20 to 500.
Scaling adjusts proportionately the height and width of the page. A lower
percentage reduces the page and a higher percentage enlarges the page.
Click OK to return to the Print dialog box.
Click OK to start printing.
Gutter increases the margins around your text and graphics on the left side and
at the top of the printed sheet. Gutter is often used for binding, hole punch, or
stapling to make a print job easier to read. This creates a larger margin space
by shifting the printable area to the right, or down, as much as one inch (25.4
mm).
You can increase the margins on the left side and at the top of the printed sheet.
In the Layout tab, click Gutter.
In the Gutter width options, type or select a value between 0.20 to 1.00 inches
(5.0 to 25.4 mm).
Short edge (top)
This selection modifies the outside margin on the top-edge of the page.
Long edge (left)
This selection modifies the outside margin on the left-side of the page.
Note: Availability of Gutter settings varies depending on Orientation and
Duplex settings in the Basic tab.
If text extends too close to the edge of the page, select Reduce image to fit.
The text appears slightly reduced and away from the edge of the page. If text
does not extend beyond the page when the gutter increases, clear Reduce
image to fit.
Layout
5-2