Custom Installation; Installing In Custom Mode With A Network Connection Using Discover - Kyocera FS-C8650DN Driver Manual

Custom Installation

Installing in Custom Mode with a Network Connection using
Discover
1
2
3
Printer Driver
With Enable Status Monitor selected, you can select this additional option
to have Status Monitor display a message on your computer when a print
job finishes printing. The default is the notification is not displayed (check
box cleared). This option is also available in Advanced > Status Monitor.
Note: With a USB connection and Status Monitor on, the message
appears when printing finishes whether the Notify when printing is
complete check box is selected or cleared.
Device Settings
Select the Device Settings check box to open Device Settings where you
can choose installed options for your printing system. (The Device Settings
check box appears only in Windows XP with a network connection.)
When the installation completes successfully, click Finish to exit the installation
wizard.
A message may appear if there is a software installation failure.
Click Finish, and retry the installation. If the same message appears again,
contact your system administrator.
The installation of the printer is now complete. If prompted, restart your
computer.
Custom Mode applies to driver installation for a USB or network connection.
The installation wizard can discover printers that are turned on, and connected
by USB and network cable, or you can manually select the driver from drivers
that are available. You can specify the printer port, fonts, and the utilities you
want to install.
Printer drivers that ship with Windows operating systems are called minidrivers.
The minidriver is available separately for PCL and KPDL and provides basic
support for your printer.
The KX XPS driver is only available for printing systems used with Windows 7,
Windows Vista, or Windows Server 2008. The XPS driver is discussed in the
Device Settings chapter. Minidriver functionality is not documented in this user
guide.
This section describes the custom installation procedure of the driver software
in Windows operating systems using a network connection.
Ensure that your printer and computer are connected to a network.
On the Installation Method page, select Custom Mode.
The Discover Printing System page opens searching for your printing system.
The Discover button is automatically selected. A list of models appears. Click
Next.
If Discover does not find your printing system, a message appears. Remove
and reinsert the network cable, and ensure it is connected properly. Click
Refresh to retry the discovery. If the system still cannot find your printing
system, contact your system administrator.
Installation
1-4