Adjust The Dmx- Address - Elation Power Wash 575E Instruction Manual

COAD
DFSE
FEED
EFLG

3.1 Adjust the DMX- Address

Right after turning on the POWER
Address. If there is no DMX- Signal the display flashes.
D001
For the address setting please follow this procedure:
1. Switch On the POWER WASH 575E
RESE
finished ('
2. Press the Mode-key in order to access the main menu. Browse through the
menu by pressing the Up/Down-keys until the display shows
by pressing the Enter-key (the decimal point is flashing)
3. Use the Up/Down-keys to select the desired address. Confirm the setting by
pressing the Enter-key (the display shows
cancel.
The DMX- Address is stored also while switching off the POWER WASH 575E
Elation Lighting
Calibration of the Zoom
ZOOM
Calibration of the Dimmer
Dimm
Calibration of the Shutter
SHUT
Settings in the internal memory (super-user only)
CLRE
Adjust Reset
ARES
Software version Tilt-board
VTIL
Software version driver board 1
VTRB1
Software version driver board 2
VTRB2
Use the code for entering the calibration menu (for
CODE
authorized persons only)
xxxx
Coarse calibration of the Cyan color wheel
CYAN
Coarse calibration of the Magenta color wheel
MAGE
Coarse calibration of the Yellow color wheel
YELL
Call on the default function values
Pan/Tilt feedback (error correction) On/Off
Correction of faults
(D001)
POWER WASH
WASH
POWER WASH 575E
' is flashing in the display).
www.elationlighting.com
575E
575E you can see the current DMX-
and wait until the fixture reset has
OK
) or press the Mode-key to
POWER WASH 575E
D001
. Confirm
!
13