Cleaning The Pre-Motor Filter - Bissell Trilogy Pet User Manual

M
aintenance and care

cleaning the pre-motor filter

check pre-motor filter and wash
as needed based on frequency of
cleaning.
1. Turn power OFF. Unplug power cord from
electrical outlet.
2. The pre-motor filter protects motor from
debris and is located in the slide out
tray underneath the dirt container. If filter
becomes dirty, pull out the tray, lift out the
foam filter pad to clean.
note: the pre-motor filter may be
hand washed in cold water with
mild detergent. Rinse well and dry
completely before replacing.
Replacing the post-motor filter cartridge
1. Turn power OFF. Unplug power cord from
electrical outlet.
2. The post-motor filter assists in the filtration
process to return clean air to the room. It
is located under the pre-motor filter tray.
The vacuum must be in reclined position to
remove the filter.
3. Using your foot, press the handle release
pedal and tilt vacuum handle back to a
60 degree angle. Push the button on the
top of post-motor filter door to unlatch and
remove the door.*
4. If the post-motor filter is dirty, remove
and replace it. The white, pleated post-
motor filter is NOT washable and must be
replaced.*
5. Replace the filter door before returning
vacuum back to upright position.
w w w . b i s s e l l . c o m
2
2
3
4
*product images may differ
from consumers' models.
8 0 0 . 2 3 7 . 7 6 9 1
11