If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a proper outlet. Do not change the plug in any way. www.BISSELL.ca...
Do not plug in your vacuum cleaner until power switch o and disconnect polarized danger of su ocation, keep away from you are familiar with all instructions and plug from electrical outlet before performing babies and children. operating procedures. maintenance or troubleshooting checks. www.BISSELL.ca...
In the second position, the brush roll spins faster to help pickup debris below the surfaces. (Recommended for carpeted areas and thick area rugs.) 1st Position 2nd Position Low Brush High Brush Roll Roll www.BISSELL.ca...
Page 6
3. Loop power cord around cord wraps on the side of the extension wand. 4. Clip molded plug to power cord to secure. NOTE: Easily unwrap the power cord by grabbing the cord wrap and turning right or left. www.BISSELL.ca...
Press the button and the bottom lid will open. WARNING 4. Close the dirt bin lid and press up until you hear a click sound that indicates it is Do not operate cleaner without fi lters in place. closed securely. www.BISSELL.ca...
Page 8
To wash the foam filter, hold filter under warm running water and squeeze 10 times. Once completed, squeeze excess water from the filter. Allow at least 24 hours to dry completely. NOTE: Filters must dry before reassembly or vacuuming. www.BISSELL.ca...
Page 9
6. Grab the cyclone cone and pull up through the hole to remove from the cyclone separator. 7. Clean the parts as necessary to remove excess dirt and debris. NOTE: These parts may be washed in warm water. Air dry completely before reassembly. www.BISSELL.ca...
Page 10
6. Turn the felt cover to the right to lock. 7. Slide the assembled cyclone back into the dirt cup. The rubber seal should fit over the cone on the dirt cup cover. www.BISSELL.ca...
Page 11
5. Check the extension wand for clogs or blockages. 6. Check the power foot dust inlet for clogs or blockages. 7. Proceed to check connection parts for clogs or blockages. 8. Clear all clogs or blockages if required. www.BISSELL.ca...
Page 12
NOTE: If the wall mount is not used, the vacuum should be stored in a safe place, in the upright position against a firm surface to prevent falling over. www.BISSELL.ca...
Please do performed by an authorized service representative. not return Thank you for selecting a BISSELL product. this product For any questions or concerns, BISSELL is happy to to the store. be of service. Contact us directly at 1-800-263-2535. www.BISSELL.ca...
Replacement Parts These items are available for your BISSELL Hand Vacuum. Call 1-800-263-2535 or visit www.BISSELL.ca PART # PART NAME PART # PART NAME 1606279 Brush Roll Clip set included left 1606282 Brush Roll and right 1606283 Wall Mount 1606284...
Subject to the *EXCEPTIONS AND EXCLUSIONS identified below, upon have questions about your warranty, contact BISSELL Consumer Care. receipt of the product BISSELL will repair or replace (with new or remanufactured components or products), at BISSELL’s option, free Website or E-mail: of charge from the date of purchase by the original purchaser, for www.BISSELL.ca...