Attach Handle To Vacuum - Bissell Trilogy Pet User Manual

A
ssembly
tools needed: philips head screwdriver.

attach handle to vacuum

1. Locate vacuum handle and the bag that
contains extension wand support, lower
cord wrap, and screws.
2. Stand vacuum upright and from the back
of the vacuum, slide the base of the handle
firmly into the grooves at the top of the
vacuum body. Continue to push so there
are no gaps and the front of the handle is
flush with front of the vacuum body.
3. Insert two of the four screws provided into
the existing holes and tighten with screw
driver to fasten handle to vacuum body.
attach storage clips, tool, and vacuum hose
1. Locate the bag that contains extension
wand support, lower cord wrap, and
remaining two screws.
2. Attach extension wand support half way
down on the back of the vacuum body.
Insert one screw and tighten with
screwdriver.
3. Attach lower cord wrap to back of the
vacuum (position toward bottom of vac-
uum body). Insert remaining screw and
tighten securely with screwdriver.
4. Attach Twist 'n Snap
tabbed end of the hose into the opening by
the clear tank on the back of the vacuum.
Twist to the right to lock into place.
5. Insert opposite hose end base into suction
inlet on the side of vacuum near the wheel.
note: the vacuum will not operate
effectively unless the hose is firmly
attached.
6. Store crevice tool into the extension
wand and snap into extension wand sup-
port on the back of the vacuum.
7. Slide dusting brush into the storage clip
on the right side of vacuum (when view-
ing from front). Model 81M9-1 comes
with Pet Contour tool
same place.
8. Store TurboBrush
"tool" on the top of the handle arch.
note: Model 81M9-1 comes with
pet turbobrush
w w w . b i s s e l l . c o m
hose by lining up the
™
that stores in
®
Tool in the hole marked
®
tool.
®
caution:
Do not plug in your vacuum
cleaner until you are familiar
with all instructions and
operating procedures.
2
2
4
8 0 0 . 2 3 7 . 7 6 9 1
3
3
5
5