Chapter  Troubleshooting - Eizo FlexScan EV2303W User Manual

Chapter  Troubleshooting
If a problem still remains after applying the suggested remedies, contact your local dealer.
• No-picture problems → See No.1 - No.2.
• Imaging problems (digital input) → See No.3 - No.8.
• Imaging problems (analog input) → See No.3 - No.12.
• Other problems → See No.13 - No.18.
Problems
1. No picture
• Power indicator does not light.
• Power indicator is lighting blue.
• Power indicator is lighting orange.
. The message below appears.
• This message appears when no signal is input.
• The message shows that the input signal is out of the
specified frequency range. (Such signal frequency is
displayed in red.)
Example:
. The screen is too bright or too dark.
. Characters are blurred.
Possible cause and remedy
• Check whether the power cord is connected correctly. If
the problem persists, turn off the monitor, and then turn it
on again a few minutes later.
• Turn the main power switch on.
.
• Press
• Set each adjusting value in [Brightness], [Contrast] and
[Gain] to higher level. (see
• Switch the input signal with
• Operate the mouse or keyboard.
• Check whether the PC is turned on.
• When the EcoView Sense is on, the monitor may have
shifted to the power saving mode. Come near to the
monitor.
This message appears when the signal is not input
correctly even when the monitor functions properly.
• The message shown left may appear, because some
PCs do not output the signal soon after power-on.
• Check whether the PC is turned on.
• Check whether the signal cable is connected properly.
• Switch the input signal with
• Check whether the signal setting of your PC matches
the resolution and the vertical frequency settings for
the monitor. (see "Compatible Resolutions" of the
Specifications Sheet)
• Reboot the PC.
• Select an appropriate display mode using the graphics
board's utility. Refer to the manual of the graphics board
for details.
fD : Dot Clock
(Displayed only when the digital signal inputs)
fH : Horizontal Frequency
fV : Vertical Frequency
• Adjust using [Brightness] or [Contrast]. (The LCD
monitor backlight has a fixed life span. When the screen
becomes dark or begins to flicker, contact your local
dealer.)
• Turn on the Auto EcoView function. The monitor detects
the environmental brightness to adjust the screen
brightness automatically.
• Check whether the signal setting of your PC matches
the resolution and the vertical frequency settings for
the monitor. (see "Compatible Resolutions" of the
Specifications Sheet)
• Adjust using [Smoothing]. (see
Chapter 4 Troubleshooting
page 18,
20)
.
.
page 16)
1