Chapter  Troubleshooting - Eizo FlexScan S2433WH User Manual

Chapter  Troubleshooting
If a problem still remains after applying the suggested remedies, contact your local dealer.
• No-picture problems → See No.1 - No.2.
• Imaging problems (digital input) → See No.3 - No.8.
• Imaging problems (analog input) → See No.3 - No.12.
• Other problems → See No.13 - No.16.
• USB problems → See No.17.
Problems
1. No picture
• Power indicator does not light.
• Power indicator lights blue.
• Power indicator lights orange.
• Power indicator flashes orange.
. The message below appears.
• This message appears when no signal is input.
Example:
• The message shows that the input signal is out of the
specified frequency range. (Such signal frequency is
displayed in red.)
Example:
. The screen is too bright or too dark.
Possible cause and remedy
• Check whether the power cord is connected correctly. If
the problem persists, turn off the main power, and then
turn it on again a few minutes later.
• Turn the main power switch on.
• Press .
• Set each adjusting value in [Brightness], [Contrast] and
[Gain] to higher level. (see
• When using the long DVI cable, adjust the DVI input
level using [DVI Input Level]. (see
• Switch the input signal with
• Operate the mouse or keyboard.
• Check whether the PC is turned on.
• There is a problem in the device that uses DisplayPort
connection. Solve the problem, and turn off the main
power of the monitor, and then turn it on again. Refer to
the user's manual of the device that uses DisplayPort
connection for details.
This message appears when the signal is not input
correctly even when the monitor functions properly.
• The message shown left may appear, because some
PCs do not output the signal soon after power-on.
• Check whether the PC is turned on.
• Check whether the signal cable is connected properly.
• Switch the input signal with
• When using the long DVI cable, adjust the DVI input
level using [DVI Input Level]. (see
• Check whether the signal setting of your PC matches
the resolution and the vertical frequency settings for the
monitor. (see page 9)
• Reboot the PC.
• Select an appropriate display mode using the graphics
board's utility. Refer to the manual of the graphics board
for details.
fD : Dot Clock
(Displayed only when the digital signal inputs)
fH : Horizontal Frequency
fV : Vertical Frequency
• Adjust using [Brightness] or [Contrast]. (The LCD
monitor backlight has a fixed life span. When the screen
becomes dark or begins to flicker, contact your local
dealer.) (see page 18)
Chapter 4 Troubleshooting
page 18, 20)
page 29)
.
.
page 29)
1