Rear Panel - Yamaha DTX500 Owner's Manual

Rear Panel

!2
!2 MIDI OUT jack
For sending data from the DTX500 to an external MIDI device.
With this jack, you can use the DTX500 as a control device to
trigger voices from an external tone generator, or synchronize
song playback or the click of the DTX500 with the playback of
an external sequencer. (p. 11)
!3 Trigger Input jacks (1SNARE thru 8KICK/9)
For connecting pads or drum triggers (Yamaha DT20, etc.) to
receive trigger signals.
Connect external pads such as a snare, tom, etc., according to the
indication below each input. (p. 10)
1SNARE ..................... Compatible with three-zone pads and the pad
controller.
2TOM1/ 0, 3TOM2/ !, 4TOM3/ @, 8KICK/ 9
.............................. Mono x 2 inputs
A Y-shaped cable (stereo plug—mono jack x
2; refer to the illustration below) can be used to
trigger inputs 9, 0, !, and @ (monaural
pad). Also, if the KP125W/125/65 kick pad is
connected to this jack with a stereo cable, the
external pad input jack on the KP125W/125/65
can be used as the input for input jacks 9, 0,
!, or @.
5RIDE, 6CRASH ..... Compatible with three-zone pads.
7HI HAT ..................... Compatible with stereo pads (with switches)
● Y-shaped cable
Stereo phone plug
!4 Hi-hat controller jack (HI HAT CONTROL)
For connecting a hi-hat controller.
* Use a cable with a stereo plug (shown below) when connect-
ing a hi-hat controller.
Double insulator
!3 !5
!5 Output jacks (OUTPUT L/MONO, R)
For connecting the DTX500 to an external amplifier, mixer, etc.
For mono playback use the L/MONO jack. For stereo playback
connect both L and R jacks. (p. 10)
!6 Headphones jack (PHONES)
Connect a set of stereo headphones to this jack to monitor the
DTX500. (p. 10)
!7 AUX IN jack
Connect the output of an external audio device, etc., to this jack
(stereo mini jack). (p. 11)
This is convenient for playing along with music from a CD
player, etc.
* Use the volume control on the external device to adjust the
volume balance.
!8 Master Volume (VOLUME)
Adjusts the DTX500's overall volume (output level of the signal
sent via the OUTPUT jacks and PHONES jack). Rotate the knob
clockwise to increase the volume, or counter-clockwise to
decrease it.
!9 DC IN terminal (12V)
Connect the supplied AC power adaptor to this terminal. To pre-
vent the adaptor from becoming unplugged, secure the cable to
the cable clip.
@0 Cable clip
Mono phone jack
Prevents the power cord from accidentally becoming unplugged.
(p. 10)
@1
Mono phone jack
The power is turned on when the button is set to this position:
(>). The power is off when set this way: (?).
Controls and Functions
!6 !7 !8
!4 !9 @0
Standby/On Switch
DTX500 Owner's Manual
@1
9