The DTX560K and DTX530K feature the same Drum units as those of the DTX700K, with the following exceptions:
- Unlike the DTX700K, both the DTX560K and DTX530K have the Drum Trigger Module DTX500.
- Unlike the DTX700K, the DTX530K has the TP65, instead of the XP70.
Accordingly, you should refer to the DTX700K Assembly Manual for details on how to assemble the pads to the rack.
The following description covers assembly of the DTX500 Drum Trigger Module only.
Mounting the drum trigger module
Attach the module stand (provided) to the
underside of the drum trigger module using the
module stand fastening screws.
Connect the pads to the drum trigger module
Insert the 9-channel snake cable's straight plugs into the drum trigger module's trigger input jacks ([ q SNARE] to
[ o KICK/ !0 ] and [HI-HAT CONTROL]).
If you are using the standard setup, the stickers on each of the snake cable's plugs will indicate the name of the
Drum trigger module's rear panel
9-channel snake cable
Drum trigger module
HH CON HI-HAT CRASH KICK SNARE TOM1
Place the module stand inside the holder clamp
and tighten the clamp bolt to secure in position.
Straight plug names
DTX500 jack names
(as shown on stickers)
1: q SNARE
2: w TOM1/ !0
3: e TOM2/ !1
4: r TOM3/ !2
5: t RIDE
6: y CRASH
7: u HI-HAT
8: i KICK/ o
9: HIHAT CONTROL
Digital Musical Instruments Division
©2011 Yamaha Corporation