Table of Contents
Advertisement
Making Connections
fig.10
* To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power
on all devices before making any connections. Set all of the PM-
1's channel volume knobs as well as the MASTER VOLUME
knob to zero.
* The pin assignment for the XLR type connectors is as shown
below. Before making any connections, make sure that this pin
assignment is compatible with that of all your other devices.
fig.21
8
Mic
Percussion Pads
Input
Recorder
Mixer
Output
Output
Output
Drum Sound Module
* Howling could be produced depending on the location of
microphones relative to speakers. This can be remedied by:
1. Changing the orientation of the microphone(s).
2. Relocating microphone(s) at a greater distance from
speakers.
3. Lowering volume levels.
Q: The volume level of the instrument connected to CH
1 – CH 4 are too low.
A: Could you be using a connection cable that contains a
resistor?
Use a connection cable that does not contain a resistor.
Stereo
Headphones
Advertisement
Table of Contents
