Table of Contents
Advertisement
Proper use of the internal stand
To avoid the risk of the unit overturning, never use the internal stand for attaching anything other than the SPD-20 or the HPD-15.
When attaching the SPD-20 or the HPD-15 to the internal stand, you must use the APC-33 (an all purpose clamp set: sold separately).
Attaching the Stand and Adjusting the Stand Height
When shipped, the stand is detached from the main unit. To
prepare the stand for use, follow the procedure below to
attach the stand to the main unit.
fig.13
Stand insertion hole
1. Loosen attachment screw 1.
2. Insert stand pipe 1 into the PM-1's stand insertion hole,
then tighten attachment screw 1.
3. Loosen attachment screw 2.
4. Insert stand pipe 2 into the insertion hole in stand pipe 1,
then tighten attachment screw 2.
This completes setup of the stand.
10
Adjust the height of the internal stand in the following way.
1. Loosen screw 1, and adjust the height of pipe 1.
2. After deciding the height of pipe 1, fasten screw 1.
3. While holding pipe 2 with your hand, loosen screw 2 and
Pipe 2
Screw 2
4. After deciding the height of pipe 2, fasten screw 2.
Pipe 1
5. After deciding the total height of the internal stand, attach
Screw 1
fig.15a
With the APC-33, adjust
the angle at which the
SPD-20 or HPD-15 is
attached.
Loosen each screw and
adjust the angle. When
you have determined the
proper angles, tighten the
screws.
Before tightening the
screws, make sure that the
hardware portions that get tightened firmly grip the arm
section, and are prevented from slipping.
If the ridges and valleys are not properly meshed, the angle
may change during the performance, possibly resulting in
injury or damage to your equipment.
* Remove the SPD-20 or the HPD-15 from the stand before
adjusting if it is already attached.
adjust the height of pipe 2.
the SPD-20 or the HPD-15 with the APC-33 already
attached.
To prevent the SPD-20 or the HPD-15 from falling while
in performance, make sure screw 1 and screw 2 are
fastened tightly.
Lateral angle
adjustment screw
Vertical angle
adjustment screw
Advertisement
Table of Contents
