Table of Contents
Advertisement
Proper use of the internal stand
Attaching APC-33 to HPD-15
When attaching the APC-33 to the HPD-15, make sure to use
35mm screw supplied with the APC-33. Using other screws
may damage the unit.
fig.14
Wide
12
Attaching the APC-33 to the
internal stand of PM-1
Attach the APC-33 to the internal stand in the following way.
1. Clamp the bar of the stand with BLOCK A and BLOCK B.
2. Fasten SCREW C slightly loose. The bar should be
clamped at the V-shape of BLOCK A and BLOCK B.
3. Fasten SCREW D tightly. Adjust SCREW C and SCREW
D so that BLOCK A and BLOCK B are in parallel.
4. After attaching to the stand, slightly shake the APD-20 or
HPD-15 to make sure it doesn't loosen.
To prevent the unit from falling during performance, make
sure the bar of the stand is clamped at the V-shape of BLOCK
A and BLOCK B, and fasten SCREW C and SCREW D
Narrow
tightly.
fig.15
Make sure the point on the stand where the APC-33 is
attached is sufficiently clear of the end of the stand.
BLOCK A
SCREW C
BLOCK B
SCREW D
STAND
Advertisement
Table of Contents
