Table of Contents
Advertisement
If the SPD-20 or the HPD-15 is installed facing the front
side (fig. C), the height of the internal stand can be as
high as 120cm (maximum).
If the SPD-20 or the HPD-15 is installed other than the
front side (fig. D), the height of the internal stand must be
under 80cm.
When the PM-1 is moved or stored, please set the internal
stand shortest for safety purpose.
Use without proper installation may result in instability
causing possible severe injury and/or property damage.
fig.06
Use under
120 cm
(fig. C)
Use under
80 cm
(fig. D)
When Attaching the SPD-20
or HPD-15 to the Stand
When attaching the SPD-20 or HPD-15 to the stand, use the
APC-33 to secure these pads to the stand.
Attaching APC-33 to SPD-20
1. Using a 4 mm wrench, remove the four screws from the
bottom of the SPD-20.
fig.22
2. Use the four screws you removed in step 1 to attach the
stand holder to the bottom of the SPD-20.
fig.23
The screws included with the APC-33 cannot be used.
Proper use of the internal stand
11
Advertisement
Table of Contents
