Table of Contents
Advertisement
CHAPTER 3: Maintenance Basics
Do not touch the contacts on the bottom
part of the expansion card. Touching the
contacts can cause electrostatic damage
Replacing the system board
Tips & Tricks
You need a Phillips screwdriver to replace
the system board.
32
Caution
Install the new card into the expansion slot. You can slightly seesaw the
6
card end-to-end to help insert the card, but do not bend the card
sideways.
to the card.
Replace the thumbscrew in the expansion card cover.
7
Reconnect the expansion card cables (if any) using your notes from
8
or, if adding a new card, follow the manufacturers instructions.
Return your computer to its upright position.
9
Replace the side panel by following the instructions in
10
panel" on page
To replace the system board:
Remove the side panel by following the instructions in
1
panel" on page
For more stability, place your computer on its side. To avoid scratching the
2
case, place it on a towel or other non-abrasive surface.
Disconnect any cables that are attached to any expansion cards, noting
3
their locations and orientation. (You will reconnect the cables after you
install the cards on the new board.)
Remove the expansion cards by following the instructions in
4
replacing an expansion card" on page
end-to-end to loosen it, but do not bend a card sideways.
15.
12.
31. You can slightly seesaw a card
www.gateway.com
Step
4,
"Replacing the side
"Removing the side
"Adding or
Advertisement
Table of Contents
