CHAPTER 3: Maintenance Basics
Adding or replacing a hard drive
Before replacing the hard drive in your
computer, you must create restore discs
and print a copy of the restore chapter in
the User Guide. If this is not done, you will
not be able to reinstall your drivers and
22
Caution
To add or replace a hard drive:
Create restore discs and print the restore chapter in the User Guide. To
1
access the User Guide, click Start, All Programs, then click Gateway
Documentation.
programs.
Remove the side panel by following the instructions in
2
panel" on page
If you are adding a new drive, go to
3
- OR -
If you are replacing an existing drive, go to the next step.
Disconnect the drive cables, noting their locations and orientation. (You
4
will reconnect the cables after you install the new drive.)
Slide the drive release latch in the direction shown.
5
Remove the hard drive by sliding it out of the drive bay.
6
12.
Step
www.gateway.com
"Removing the side
7.