Table of Contents
Advertisement
www.gateway.com
Important
The color and shape of your replacement
reader's front cover may vary from your
original reader.
Remove the thumbscrew holding the card reader in the drive bay.
5
Slide the drive release latch back to release the card reader, then slide the
6
card reader out of the case.
Note any jumper settings on the old card reader and set the new card
7
reader jumpers the same. If you are installing a new card reader, refer to
the instructions that came with the card reader.
Slide the new card reader into the bay from the front of the case, then slide
8
the drive release latch forward to lock the drive into place. You do not
need to replace the thumbscrew because it was originally installed for
shipping purposes.
Connect the new card reader cables, using your notes from
9
are adding a new card reader, refer to the instructions that came with the
card reader.
Replace the bezel by following the instructions in
10
bezel" on page
14.
Replace the computer case's side panel by following the instructions in
11
"Replacing the side panel" on page
Adding or replacing the memory card reader
Thumbscrew
"Replacing the front
15.
Step
4. If you
21
Advertisement
Table of Contents
